All posts by Bernard Hatt
Below are all of Bernard Hatt's postings, with the most recent are at the bottom of the page.
B
Hemel Hempstead (Hertfordshire, England) Full Freeview transmitWednesday 18 April 2012 11:29PM
Hemel Hempstead
Just been rescanning/retuning my Freeview receiver attached to a Linux computer, and everything works fine apart from COM4/SDN and COM5/ArqA.
Both are shown on your listing with the FEC value of 2/3, but I can only tune in to scan with the value of 3/4.
Not sure if it's a problem with your listing or my software, but I thought I'd mention it in case anyone else has a similar problem.
| link to this comment |
Saturday 17 September 2011 11:42AM
Just found out about the channel change in Hemel:
Mux 1 690MHz -> 754MHz
Mux A 786MHz -> 850MHz
(re-tune and everything is fine - I'm almost line of sight to the transmitter).
Is there any way to subscribe just frequency/channel changes like this, for just this transmitter, so I can find out in advance ?
Thanks,
Bernard