menuMENU    UK Free TV logo Archive (2002-)

 

 

Click to see updates

All posts by John Kirby

Below are all of John Kirby's postings, with the most recent are at the bottom of the page.


After the switch over on Sandy Heath March/April we will have to do a re-tune, there has been mention of another re-tune later on in the year, is there any info on this one and why.

link to this comment

I am in the Cambridgeshire and feed off the Sandy Heath transmitter. When I did a rescan on the 30th. I was left with three selections as follows:

Cambridge and Beds. 18 services
Cambridge and Beds. 21 services
Midlands. 18 services

I know that I can ignore the Midlands(Waltham) but which of the other two should I select, I can only select one.

link to this comment
J
Sandy Heath (Central Bedfordshire, England) Full Freeview trans
Wednesday 23 November 2011 10:37AM
Chatteris

I am on Sandy Heath and I did a manual retune. MUX C shows as C67 but channels are showing no service available. I also tried C52 but no difference. Is there a problem with MUX C.

link to this comment

Do we know when Sandy Heath will be on full power instead of above average and Low?

link to this comment
J
Sandy Heath (Central Bedfordshire, England) Full Freeview trans
Friday 27 September 2013 11:22PM
Chatteris

Sandy Heath transmitter. Total loss of channels, must be a reason, had some interference last couple of weeks as well, what's going on, I have had 10years excellent signal from Sandy Heath.

link to this comment
J
Sandy Heath (Central Bedfordshire, England) Full Freeview trans
Friday 27 September 2013 11:37PM
Chatteris

JohnMcG.

I dare say we will get an answer in due course, no need for you to go up there :-)

link to this comment
J
Sandy Heath (Central Bedfordshire, England) Full Freeview trans
Saturday 28 September 2013 7:40AM
Chatteris

Saturday 7.30am. All is back to normal it appears from Sandy Heath.
Will we get an explaination as to what the cause was?

link to this comment
J
Sandy Heath (Central Bedfordshire, England) Full Freeview trans
Thursday 12 December 2013 9:35AM
Chatteris

With the added four new HD channels, I was mis-lead in the MUX section COM7 that they were available from September 2014. At first I didn't bother on the 10th Dec. until I was informed on another forum that they were available, I now have them. Can you please do away with that Sept.2014 notification?

link to this comment
Page 1