News
TV
Freeview
Freesat
Maps
Radio
Help!
Archive (2002-)
All posts by Danny
Below are all of Danny's postings, with the most recent are at the bottom of the page.D
My Freeview box has no EPG, is blank on FIVE, ITV3, ITV4, ITV2+Saturday 12 November 2011 4:50PM
Hatfield
Hi Dave, Thanks for your reply. :)
The splitter is an outdoor one. I have replaced it with a new one but no change. The cable runs are around 10 meters. You may be right, I may have to low a signal to split it. However they both worked fine before last Saturday. I will try and remove the splitter but at the moment I do not have a single connector to use so I will have to pop to the shops. Thanks again
link to this comment |
D
My Freeview box has no EPG, is blank on FIVE, ITV3, ITV4, ITV2+Sunday 13 November 2011 10:23PM
Hatfield
Danny: Thanks again Dave. I think you are right. I'll have a look at the page now. Do you think this would be considered an installation fault? I only ask as if not they said they will charge me £40 call out.
Thank you
link to this comment |
Saturday 12 November 2011 3:36PM
Hatfield
Hi I live in Hatfield, AL10 9RX. Last Saturday 5th, I lost or had really bad reception on all freeview channels. I have an outdoor Aerial I brought & had installed less than a year ago. I think it is a good aerial & until saturday I had all channels perfectly. I have two TV's in two different rooms, both were effected but one got some channels which the other one did not receive. I rescanned & got next to nothing last week. I rescanned both again yesterday & now the one in the bedroom is only missing Multiplex 2 channels (itv, C4, C5, Itv2, E4, More4). Strangely the one in the living room gets even less channels. I can get ITV1 via anolouge, its a bit grainy but I get it. I installed another two way splitter but it did not make any differences. I have one years guarantee on the aerial Install. When I called them to ask them to come & look at it they said if its proved it is not an installation error I have to pay £40. I would like to ask do you think this sounds like an install problem? And do you have any other ideas I could try? Thank you.