Help with Television sets?
Wednesday, 26 January 2011
B
brett1:49 PM
trying to retune my digitrex tv ctf3271, keeps saying no signal, and wont retune freeview but tv is tuning the basic 4 channells
| link to this comment |
Thursday, 17 February 2011
M
MARIO8:35 PM
Newry
HI I have bought low energy digital set top box fro freeview- GUD1500X12. I have connected all required leads to my flat screen tv. However the only signal i get is all the radio stations. Is it not possible to watch freeview in analog tv ?
| link to this comment |
MARIO's: mapM's Freeview map terrainM's terrain plot wavesM's frequency data M's Freeview Detailed Coverage
Friday, 18 February 2011
MARIO: You won't get any Freeview until 2012. Freeview is a digital service.
| link to this comment |
Wednesday, 29 June 2011
D
Daniel peake12:47 PM
I used to live in Newcastle, and my Phillips tv worked fine on digital. It has digital built in to it. But since iv moved to Glasgow I can't get any digital tv. The analogue television gets like 3 channels and they are such bad quality that it's unwatchable. Iv had the maintenence guy out to have a look at the areal socket in the wall and he took it apart n back together but it made no difference. Any suggestions please !!!
| link to this comment |
M
Mike Dimmick1:58 PM
Daniel Peake: Have you just moved in the last week?
The last Scottish analogue transmissions were switched off last Wednesday morning. You will need to do a full retune on your TV if you haven't already. It might be called Full Reset, Default Setting, or First-Time Installation, and it might be under the Software Update menu rather than the tuning menu. Add Channels is not enough, you need it to completely remove everything it previously knew about where the channels were.
TV Re-tune may have a guide for retuning your TV, or a copy of the manual.
It's possible that your TV cannot handle the 8K mode used for post-switchover transmissions. Check whether it's on the list at http://www.digitaluk.co.uk/2kequipment , and check with Philips whether any software/firmware updates are available.
| link to this comment |
lesnicol
2:12 PM
2:12 PM
Daniel Peake. If you get no results with the advice Mike's given you, you could try removing the aerial connection to the set. Again follow Mike's directions above,once done, re-connect the aerial and run First-Time install again. Hopefully the process will have wiped the memory as it was when in Newcastle and give you a satisfactory re-install of the digital channels from Blackhill.
| link to this comment |
Thursday, 14 July 2011
M
MALCOLM11:04 AM
Ihave a bush dfta11 freeview box that worked perfecly ok up and until the digital switchover and all we get now is a handful of channels, there are no bbcs, itvs, c4, 5, yesterday etc etc, is there a procedure to retune the box? have tried many times to do standard installation but to no effect
| link to this comment |
Sunday, 17 July 2011
MALCOLM: Is the box listed on this page TVs and boxes that do not support the 8k-mode | ukfree.tv - independent free digital TV advice ?
| link to this comment |
Wednesday, 3 August 2011
A
adele9:38 PM
im in scarborough, we had are change over today we have done everything we have been told to re adding all the channels again, now we dont have bbc1 and bb2 :( can anyone help x
| link to this comment |
Select more comments
Your comment please