All posts by Jonny
Below are all of Jonny's postings, with the most recent are at the bottom of the page.
thanks Brian. What I dont understand is why its been working fine for a couple of years and then pretty much just gradually deteriorated over the last 3 months. Its almost as if the batteries were going flat in the the remote - you would have to press 3 or 4 times to get a response (obviously batteries changed!) Now there is no response at all and you have to change the channel in the room with the hd box. I have used the antiference splitter to allow the 4 magic eyes to work without probs until now. There is a light on it that lights up with the RF2 output cable attached. All the magic eye lights light up too.???
| link to this comment |
Hi Brian / jb38 with respect to my issue with the antiference remotelink 4-room amp and my sky hd box, I tried your suggestion jb and can use one feed direct into my rf2 and change channels fine from that room. My thoughts were that the antiference box had stopped working so I bought a new one. Again perfect picture on all 4 tellys feeding from it but still cant change the channel or control the box from anywhere other than the room with the sky box in it. magic eyes all still blink at each telly but dont change the channel. aaargh
| link to this comment |
Friday 27 May 2011 8:53PM
Hopefully you guys can help
Have sky hd box with a connection from my antiference splitter going to 4 different tvs. All tvs have magic eyes. It became increasingly difficult to change channels via the magic eyes on any of the tvs and now they have stopped working altogether. The magic eye red light is on and it blinks when you press the remote. The picture is fine on all tvs but the remote control cannot change the channel. Only way to change channel is on main box. Had sky out and they say the RF2 is fine. Antiference light is on too. Where is the problem???