All posts by Ian Craig
Below are all of Ian Craig's postings, with the most recent are at the bottom of the page.
Hi Brian,
Thanks for your post. TV is set to analogue and I have tried manual and autotuning on analogue settings. There is no conflict with Ch68 and I have also altered the analogue output channel on the Sky box to no avail. I have also re-terminated the co-ax plugs on both ends of the cable run. TV still says no signal. I think the Sky box must be duff? Anyone agree?
| link to this comment |
Friday 4 November 2011 11:47PM
I'm trying to get a signal to second tv in bedroom from a Sky+ HD box. I've connected a coax cable from the RF2 outlet on the back of the sky+ HD box and plugged the other end into the bedroom TV (RF/coax antenna). Bedroom TV gives a message "no signal" when I try to tune it. I've been into the installer/engineer menu in the Sky+HD box (the output chnnael is set to 68 and the power is on). Is there anything else that needs "switched on"? Is the RF2 outlet always "live"? Or could it simply be a dodgy coax cable - the run is approx ten metres and I fittde the plugs? The TV is working fine via alternative aerial input?